A Step-by-Step Guide for JC V1SE Programmer Driver Installation

JC V1SE Programmer, a popular iPhone screens, batteries and Face ID repair tool, has gained immense popularity among mobile repair technicians. In this blog post, PHONEFIX will guide you through the step-by-step installation of the JC V1SE Programmer USB driver. 

Part 1: Open JCID repair software

1.  Connect the V1SE programmer to your computer.
   
2.  Launch the JCID repair software and click on "Repair Fitting."  to verify device name and serial number display.

Normally, the platform should recognize the device name and serial number automatically and display on the screen. If it doesn't, proceed to the next step.

Part 2: Installing the V1SE Driver

1. Open the V1SE driver installation and click on the drop-down arrow next to "Install Driver."
2. Select "FT232 Driver General" from the options.
   
3. A black pop-up window will appear, indicating that the driver is being installed.
4. Once the pop-up window disappears, restart your computer and relaunch the JCID repair software.
5. Click on "Repair Fitting" again.
   

The software should now automatically recognize the device name and serial number.  If the device name and SN still can’t be recognized, then FT232 Driver Dedicated driver is needed.

Part 3: Installing FT232 Driver Dedicated or CH341 Driver

1. Select "FT232 Driver Dedicated" from the options.
   
2. Click on "Extract ",  "下一页" (Next Page). "完成" (Finish).
3. Restart the computer and the JCID Repair software again
4. Click on "Repair Fitting"

The software should now automatically recognize the device name and serial number.  If the device name and SN still can’t be recognized-then CH341 driver is needed.

1. Select "CH341 driver" from the options.
2. Click on  "完成" (Finish).
3. Restart the computer and the JCID Repair software again
4. Click on "Repair Fitting"

The software should now automatically recognize the device name and serial number.  If the device name and SN still can’t be recognized-then CH341 Reserved driver is needed.

Final Solution: Installing CH341 Reserved driver

If the driver for V1SE/V1S is not installed successfully, please follow the steps below. Make sure that the V1SE or V1S is connected to the platform during the following operations:

1. Connect the V1SE/V1S to the JC Repair Operation platform.
2. Enter the "Nand/P13" interface and click on "DevManager".
   
3. In the "DevManager" window, locate and perform the following actions:
   Expand the following categories:

• Sound, video, and game controllers
• Storage controllers
• System devices
• Universal Serial Bus controllers

1. Locate the driver with "USB Serial Converter" under the "Universal Serial Bus controllers" category. Right-click on it and select "Uninstall" to remove the driver.
   
2. Or Click on "Port(COM and LPT)." Uninstall the "Port (USB Serial Port)."
3. Select "CH341 Reserved driver" from the options.
4. Click on  "完成" (Finish).

It now shows New Devide V1SE on the software. Click on "Repair Fitting" to confirm automatic recognition of the device name and serial number.

Remember to carefully follow each step in the guide to ensure a smooth and successful installation of the V1SE driver.

Part 4: Solution for Driver Installation Failure

If the driver installation failure persists after following the above steps, please consider the following:

• Make sure you have the correct version of the driver for your device.
• Check if there are any compatibility issues between the driver and your platform.
• Try reinstalling the driver using the original installation package or obtaining the latest driver version from the manufacturer's website.